HP Embedded Capture Device License 1-100 E-LTU Manual de usuario Pagina 100

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 99
3.6 Using the TWAIN driver
3.6.1 TWAIN Manager
The TWAIN Manager is used to define the behavior of the HP Embedded Capture TWAIN solution.
Figure 3-4 TWAIN — Manager user interface
The following defined TWAIN parameters can be configured:
Table
3-1 TWAIN parameters
Default language — The driver will use the selected available language for UI interface and application messages.
Interface
Non-interactive — No UI will be displayed after submitting a scan job. A valid Default Printer Address should be defined to allow
non-interactive mode operation.
Interactive — After submitting a scan job the driver will display a screen where user can define the scan parameters. User will be
allowed to change the default or add new printer addresses on the TWAIN UI.
Default Printer address — Default device address used by the driver when non-interactive mode is selected. It is also default device
address used in interactive mode if user doesn’t perform any change on the TWAIN UI after posting the scanning job.
Clicking the Template Manager button opens the application that is described in the next section.
3.6.2 Template Manager
From the Template Manager, users can change default scan settings, or create new scan templates that can
be used in future scan operations.
90 Chapter 3 TWAIN
Vista de pagina 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 108 109

Comentarios a estos manuales

Sin comentarios