HP PROCURVE 8212ZL Manual de usuario descargar pdf (Pagina 168)

157

Software Fixes in Release K.11.12 - K.13.49

Release K.11.63

The following problems were resolved in release K.11.63

■ 802.1p QoS (PR_1000368188) — 802.1p prioritization may not work once a trunk is

enabled on a module, unless the user issues the commands "qos type-of service

ip-precedence" or "qos type-of service diff-services".

■ Crash (PR_1000368540) — The switch may crash with a message similar to:

Software exception at parser.c:8012 -- in 'mSess2',

task ID = 0x90e10e0 -> ASSERT: failed.

■ Menu/Event Log (PR_1000319407) — Disabling of event log numbers, via the "no

log-numbers" CLI command, doesn't work properly when viewing the event log via the Menu.

Using the 'next' and 'prev' buttons causes the log numbers to reappear.

■ PCM Traffic Monitoring/Performance Degradation (PR_1000370061) — The switch

is affected by PCM traffic monitoring, causing throughput degradation.

■ RADIUS (PR_1000358525) — Attributes that were overridden by RADIUS (CoS, Rate, and

ACL) remain active if an authenticated user fails to send EAP-LOGOFF.

Release K.11.64

The following problems were resolved in release K.11.64 (not a general release)

■ Crash (PR_1000372604) — When multiple of instances of sFlow have been configured via

the CLI, the switch may crash with an error similar to:

Software exception at sflow.c:1170 -- in 'mEaseCtrl',

task ID = 0x80e5fe0-> ASSERT: failed.

■ Enhancement (PR_1000376406) — Loop Protection feature additions, including packet

authentication, loop detected trap, and receiver port configuration.

■ Event Log (PR_1000373796) — Selecting "Save", within the IP Configuration screen of

the Menu causes unnecessary Event Log messages.

■ sFlow/Flow-Control (PR_1000375851) — To protect performance if Flow-Control is

enabled on any one or more ports , egress sFlow sampling will be disabled on all ports and

a CLI/Event Log message will be generated.

■ VLAN/CLI (PR_1000368900) — VLAN names over 12 characters in length cause the output

from the command "show ip route" to be displayed incorrectly.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 218 219

Sin comentarios

HP PROCURVE 8212ZL Manual de usuario Pagina 168