HP Remote Graphics Software (RGS) Manual de usuario Pagina 99

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 247
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 98
The functionality of each option is as follows:
[-v | -ver | -version] —Displays the Sender version information.
[-h | -help | -?] —Displays the rgsender.sh command line options that are listed on this page.
Uninstalling the Sender on Linux
To uninstall the RGS Sender on Linux, perform the following steps:
1. Log in as root.
2. If the default install.sh was used, then the following command should report some variation of the
following packages:
# rpm -qa | grep -i rgsender
rgsender_linux_64-5.4.7-1
rgsender_config_64-5.4.7-1
3. To remove the rgsender package (and corresponding configuration rpm if used), execute the
command:
rpm -e --allmatches rgsender_linux_64 rgsender_config_64
4. If the rgsender_config_64-*.rpm was installed, it must be removed first (or together as
demonstrated above) before removing the rgsender_linux_64-*.rpm package. This resolves
dependencies between the packages, and undoes the previous customizations performed by this
rpm. If you are upgrading your system from a previous version of RGS, it is suggested that you
remove both packages, and then apply the new software rpms for supported results.
Installing RGS on Linux
83
Vista de pagina 98
1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 246 247

Comentarios a estos manuales

Sin comentarios