Hp OpenView Storage Management Appliance and Software Manual de usuario Pagina 119

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 146
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 118
Migrating Event Notification Settings
103Storage Management Appliance Software V2.0 User Guide
5. Choose where to send the previously configured notification settings.
Either create a new user account, or send the notifications to an existing user
account. You can choose only one of these destinations for each previous
recipient's settings. You cannot migrate previous settings to both a new and an
existing user.
To continue, follow the instructions in the appropriate section:
See “Creating a New Notification Recipient Account,” on page 103
See “Sending Notifications to an Existing Account,” on page 106
Creating a New Notification Recipient Account
When you migrate notification settings from a previous installation, you can
create a new recipient who will receive the notifications. By default, this new
Storage Management Appliance user has a disabled status and a disabled user
account cannot receive notifications. As a user assigned the Administrator
privilege level, you can change the status to enabled at a later time. See Setting
Additional User Properties,” on page 29 for detailed information.
Note: Remember, if you want greater security while working with users and their
passwords during the notification migration, change http to https in the browser
address box and press Enter. The Notification Migration wizard restarts as a secure site.
You can then continue with the procedure below.
Clicking Secure site (at the bottom of the Create New User page) also sets the browser
to https, but it opens the Management Appliance Home page as a secure site in a
separate browser window and you must start over.
Use this procedure to create a new notification recipient account.
1. If necessary display the Event Notification Migration wizard second page
(Figure 72). See “Using the Migration Wizard,” on page 102.
Vista de pagina 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 145 146

Comentarios a estos manuales

Sin comentarios