Hp XP LUN Configuration and Security Manager Software Manual de usuario descargar pdf (Pagina 16)

16 LUN Manager for the XP10000/XP12000

In Figure 5, the hosts in the hpux-G01 group can access LUN0 and LUN1 associated with the same host

group, but cannot access LUN0 and LUN1 in the winG02 host group. The hosts in hpuxG01 can only

access the two LUs, identified by 01:05 and 02:01; the hosts cannot access the LUs 02:00 and 02:02.

Figure 5 Host group example 3 (LUN security)

If LUN security is disabled, the hosts will not be able to access most of the LUs. Hosts will have access to

only those LUs defined in host group 0.

By default, LUN security is disabled on a port, so host group 0 is the only accessible host group reserved

for the port. Initially it contains no LUs or WWNs.

When security is disabled, only LUs defined in host group 0 are accessible to hosts connected to the port,

regardless of any WWNs that may be defined for a host group. After security is enabled, WWNs are

used, permitting or restricting access based on WWN.

If you have more than one host group defined on a port, you can locate host group 0 by disabling LUN

security from the port. When done, the tree display will “gray” out all host groups except host group 0.

RAID Manager command devices

To use RAID Manager commands for Business Copy XP and Continuous Access XP operations, you must

designate at least one LDEV on the disk array as a command device. A command device receives RAID

Manager commands entered from hosts. When you enter a RAID Manager command from a host, the

command is transferred to the target device via the command device.

If you want to restrict access to LUs and by RAID Manager, you can apply command device security in LUN

Manager.

Restrictions

You cannot use the following LDEVs as command devices:

• Volumes that do not have read/write access

• Volumes reserved by Auto LUN

• Continuous Access XP volumes

• BC volumes

• External LUs

• Flex Copy volumes

• Volumes on which VMA is set

• Virtual volumes

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 83 84

Sin comentarios

Hp XP LUN Configuration and Security Manager Software Manual de usuario Pagina 16