
A RAID Manager command reference
This appendix describes RAID Manager commands corresponding to actions in RWC.
RAID Manager commands for Remote Web Console operations
The following table lists a mapping of the operations for logical device and pool that you can
perform in RWC to the RAID Manager commands.
RAID Manager commandRWC OperationItem
raidcom add ldevCreate LDEVsLogical Device
raidcom delete ldevDelete LDEVs
raidcom modify ldevEdit LDEVs
raidcom add snap_poolCreate PoolsPool
raidcom add snap_poolExpand Pool
raidcom delete poolDelete Pools
raidcom modify poolEdit Pools
raidcom modify poolRestore Pools
Remote Web Console and RAID Manager pair status names
The RAID Manager pair status name may be different than the RWC pair status name. The following
table shows a mapping of RWC pair status names to RAID Manager pair status names.
RAID Manager pair status nameRWC pair status name
SMPLSMPL (is not shown)
COPYCOPY
PAIRPAIR
SSUSPSUS
RCPYRCPY
PFULPFUL
PFUSPFUS
PSUEPSUE
For more information about the pair status definitions, see “Pair status definitions” (page 44).
Statuses required for RAID Manager pair operations
The pair must have a specific status to perform pair operations. The following table lists the RAID
Manager pair operations and the required status to perform the operation.
Required statusRAID Manager pair operation
SMPLpaircreate
PAIR/PFULpaircreate –split
PAIR/PFULpairsplit
RAID Manager commands for Remote Web Console operations 67
Comentarios a estos manuales