Hp A3312A Manual de usuario descargar pdf (Pagina 37)

DDS Tape Module

Loading a DDS Tape Cartridge

DDS Tape Module

Loading a DDS Tape Cartridge

CAUTION! Only cartridges labeled "DDS" should be used in the DDS tape module. Do

not use cartridges labeled "DAT". They will jam in the tape mechanism and damage to the

mechanism will not be covered by the warranty. Also, only apply one label to a DDS tape

cartridge to avoid jamming the tape mechanism.

NOTE! Do not try to force the DDS tape cartridge into the cartridge slot. If it does not load

properly, the cartridge will be ejected after 10 seconds. You can then load the DDS tape

cartridge again.

To load a DDS tape cartridge (see Figure 19):

1. Insert the DDS tape cartridge squarely into the cartridge slot in the direction of the embossed arrow

on top of the cartridge.

2. Gently push the DDS tape cartridge into the cartridge slot until the autoloading mechanism takes the

cartridge. The load sequence takes about 20 seconds. During the load sequence, the tape light flashes

green. When the load sequence has completed, the tape light will turn steady green.

Figure 19. Loading a DDS Tape Cartridge

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 148 149

Sin comentarios

Hp A3312A Manual de usuario Pagina 37