HP DC5100 Manual de usuario descargar pdf (Pagina 36)

2-26 www.hp.com Hardware Reference Guide

Hardware Upgrades

The 3.5-inch bay is located underneath the optical drive. To install a

drive into the 3.5-inch bay:

✎

Install guide screws to ensure the drive will line up correctly in the

drive cage and lock in place. HP has provided extra guide screws

(four 6-32 standard screws and four M3 metric screws), installed in

the front of the chassis, under the computer cover. The hard drive uses

6-32 standard screws. All other drives use M3 metric screws. The

HP-supplied M3 metric screws are black and the HP-supplied 6-32

standard screws are silver.

1. Follow the procedure described in the “Removing an Optical

Drive” section to remove the optical drive and access the 3.5-inch

drive bay.

2. Position the guide screws on the drive into the J-slots in the drive

bay 1. Then, slide the drive toward the rear of the computer 2 to

secure the drive in the J slots.

Installing a Drive into the 3.5-inch Drive Bay (Hard Drive shown)

3. Slide the drive cage back into the chassis until it locks into place.

376293-002.book Page 26 Friday, February 18, 2005 3:02 PM

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 57 58

Sin comentarios

HP DC5100 Manual de usuario Pagina 36