HP EliteBook Folio 1040 G2 Notebook PC Bundle Manual de usuario Pagina 44

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 88
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 43
6 Power management
NOTE: A computer may have a power button or a power switch. The term power button is used throughout
this guide to mean both types of power controls.
Shutting down (turning o) the computer
CAUTION: Unsaved information is lost when the computer shuts down.
The shutdown command closes all open programs, including the operating system, and then turns o the
display and computer.
Shut down the computer under any of the following conditions:
When you are connecting an external hardware device that does not connect to a Universal Serial Bus
(USB) port
When the computer will be unused and disconnected from external power for an extended period
Although you can turn o the computer with the power button, the recommended procedure is to use the
Windows shutdown command:
NOTE: If the computer is in the Sleep state or in Hibernation, you must rst exit Sleep or Hibernation before
shutdown is possible by briey pressing the power button.
1. Save your work and close all open programs.
2. From the Start screen, point to the upper-right or lower-right corner of the screen.
3. Click Settings, click the Power icon, and then click Shut down.
– or –
Right-click the Start button in the lower-left corner of the screen, select Shut down or signout , and
then select Shut down.
If the computer is unresponsive and you are unable to use the preceding shutdown procedure, try the
following emergency procedures in the sequence provided:
Press ctrl+alt+delete. Click the Power icon, and then click Shut Down.
Press and hold the power button for at least 5 seconds.
Disconnect the computer from external power.
Press and hold the power button + volume mute button for at least 5 seconds to perform a hardware
reset turning o the computer immediately.
Setting power options
Using power-saving states
Sleep is enabled at the factory.
When Sleep is initiated, the power lights blink and the screen clears. Your work is saved to memory.
34 Chapter 6 Power management ENWW
Vista de pagina 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 87 88

Comentarios a estos manuales

Sin comentarios