HP OmniBook 2000/5700 Manual de usuario descargar pdf (Pagina 65)

Expanding the OmniBook

Connecting Devices

3-15

To set up a PC card or parallel port CD-ROM drive

The general steps for setting up a PC card CD-ROM drive are as follows:

1. Copy the device drivers—from the installation software provided with the

CD-ROM drive—to the Support Utility disk into the A:\tools directory.

2. Add the device=driver statements to the CONFIG.SYS file on the Support

Utility disk. The device statements should immediately follow the [USERCD]

label.

3. Check the AUTOEXEC.BAT file to make sure that the CD-ROM drive is assigned

as drive G:.

Before the OmniBook can recognize the CD-ROM drive, you’ll need to edit the

CONFIG.SYS and AUTOEXEC.BAT files on the Support Utility disk. The required

device-drivers statements come from the CD-ROM manufacturer.

What you’ll need from your CD-ROM manufacturer

1. The names of the device drivers to copy to the Support Utility disk.

2. The device=drivers statements to add the CONFIG.SYS file.

3. Statements that the CD-ROM drive may need to add to the AUTOEXEC.BAT file.

Hint

Both the CONFIG.SYS and AUTOEXEC.BAT files contain comments that should help

your CD-ROM manufacturer advise you in editing the files to meet the particular

requirements for your device

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 99 100

Sin comentarios

HP OmniBook 2000/5700 Manual de usuario Pagina 65