HP Remote Graphics Software (RGS) Manual de usuario descargar pdf (Pagina 49)

33: : timer

48: [ 1- 0]: digital audio playback

56: [ 1- 0]: digital audio capture

Use an audio device only if it contains the word capture (device number 24 or 56 in the example above).

Between each pair of square brackets, the

rst number is the sound card and the second number is the mixer

device.

Use the following syntax to set the audio capture device, where C is the sound card number and D is the mixer

device number:

Rgsender.Audio.Linux.DeviceName=plughw:C,D

Using the example above, you could specify audio device number 24 like below:

Rgsender.Audio.Linux.DeviceName=plughw:0,0

You could alternatively specify audio device number 56 like below:

Rgsender.Audio.Linux.DeviceName=plughw:1,0

Virtual audio driver

The virtual audio driver for Linux can be used on a sender that does not have a physical audio device. In some

cases, it might be desirable to disable the physical audio device and install the virtual audio driver. The driver

and appropriate libraries need to be compiled and installed to match the current Linux kernel. The source

code and instructions for installation are in the le virtual_audio_driver.tar.

NOTE: The virtual audio driver for Linux is not supported in a virtual machine. Timing information from the

kernel in a virtual machine may not be precise enough to ensure consistent audio quality.

Remote Clipboard

Remote Clipboard allows you to cut, copy, and paste data between the receiver and the sender or between

two dierent senders.

Remote Clipboard is supported in the following scenarios:

●

Between the receiver and the sender—The sender can be running either Windows or Linux, but the

receiver must be running Windows.

●

Between two dierent senders—Both the receiver and the sender can be running either Windows or

Linux.

On Windows, Remote Clipboard must be enabled during both the RGS Sender and RGS Receiver installations

(see Installation on page 6).

On Linux, Remote Clipboard is installed by default.

On both Windows and Linux, Remote Clipboard must also be enabled in RGS Receiver (see Connection

on page 16).

TIP: Setting the logging level of RGS Receiver or RGS Sender to DEBUG enables Remote Clipboard log

information.

Remote Clipboard 39

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 96 97

Sin comentarios

HP Remote Graphics Software (RGS) Manual de usuario Pagina 49