HP 110 Wireless-N Router Series Manual de usuario Pagina 110

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 182
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 109
108 CHAPTER 5: CONFIGURING THE ROUTER
RIP RIP (Routing Information Protocol) - RIP allows the network administrator
to set up routing information on one RIP-enabled device (this Router),
and send that information to all RIP-enabled devices on the network.
Figure 85 RIP Parameter Screen
You can set up RIP independently on both LAN and WAN interfaces.
1 Check the Enable RIP checkbox.
2 Check the Enable Auto summary checkbox. Auto summarization sends
simplified routing data to other RIP-enabled devices rather than full
routing data.
3 Select the Operation Mode:
Disable — RIP is not enabled for the WAN or LAN interface.
Enable — RIP is enabled for the WAN or LAN interface. The router will
transmit RIP update information to other RIP-enabled devices.
Silent — RIP is enabled, however the Router only receives RIP update
messages, it will not transmit any messages itself.
4 In the Version field, select 1 or 2.
3Com recommends that you only use RIPv1 if there is an existing
RIP-enabled device on your network that does not support RIPv2. In all
other cases, you should use RIPv2.
Vista de pagina 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 181 182

Comentarios a estos manuales

Sin comentarios