Hp Insight Management-Software Manual de usuario descargar pdf (Pagina 59)

2. Upgrade the VC Domain firmware to the latest version for FlexFabric support.

3. Save the configuration.

IMPORTANT: HP recommends that you save the configuration so that if there is a problem

with the VC firmware upgrade you can restore the system to the last configuration snapshot.

4. Unassign any Flex-10 NICs with profile connections that are attached to the interconnect bays

being replaced. This can be done by unassigning the Ethernet connection in the profile. HP

recommends that you do this in order so you do not lose the MAC addresses.

5. Delete any existing Ethernet network connections that were created using uplinks from the

interconnect bays being replaced.

6. Remove the existing Ethernet modules from bays one and two.

7. Add the two FlexFabric modules in both horizontally adjacent bays one and two.

8. Follow the Virtual Connect Domain Setup Wizard, and select the option to restore the domain

for the saved configuration file in Step 3.

9. Create new Ethernet network connections and FC SAN Fabrics connections linked to the

FlexFabric module uplink ports.

10. Create a new VC Domain Group using the latest version of VC firmware in VCEM with this

VC Domain and using the HP Virtual Connect FlexFabric 10Gb/24port module.

After performing all the steps in “Replacing VC Ethernet modules in interconnect bays one or two

with FlexFabric modules in an existing VCEM managed VC Domain” (page 58) you can create,

or edit any existing server profiles and use the available networks or SAN Fabrics from the FlexFabric

module to create FCoE or iSCSI connections.

Replacing VC Ethernet in interconnect bays three to eight with FlexFabric in an existing

VCEM managed VC Domain

This scenario describes how to replace existing VC-Ethernet 10/10Gb-F modules in interconnect

bays three to eight with FlexFabric modules in an existing VC Domain. It also describes how to

start using FlexFabric functionality in existing or new server profiles.

1. Remove the VC Domain from the existing VC Domain Group.

2. Upgrade the VC Domain firmware to the latest version of VC firmware for FlexFabric support.

3. Save the configuration.

IMPORTANT: HP recommends that you save the configuration so that if there is a problem

with the VC firmware upgrade you can restore the system to the last configuration snapshot.

4. Unassign any Flex-10 NICs with profile connections that are attached to the interconnect bays

being replaced. This can be done by unassigning the Ethernet connection in the server profile.

HP recommends that you do this in order so you do not lose the MAC addresses.

5. Delete any existing Ethernet network connections that were created using uplinks from the

interconnect bays that are to be replaced.

6. Remove the existing Ethernet modules from bays three, four, five and six.

7. Add the two FlexFabric modules in both horizontally adjacent bays three and four.

8. Create new Ethernet network connections and FC SAN Fabrics connections linked to the

FlexFabric module uplink ports.

9. Create a new VC Domain Group with the latest version of firmware in VCEM using this VC

Domain (with the HP Virtual Connect FlexFabric 10Gb/24port module).

10. Reassign the existing Ethernet connections in the server profiles or add new connections to

the server profiles, depending on what was selected in Step 4.

11. Edit an existing server profile and add a network connection that uses the FlexFabric uplink

port.

Using FlexFabric modules 59

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 151 152

Comentarios a estos manuales

Sin comentarios

Hp Insight Management-Software Manual de usuario Pagina 59

Comentarios a estos manuales

Relacionado con productos y manuales para Software Hp Insight Management-Software