Hp Parallel Uninterruptible Power System Manual de usuario Pagina 83

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 115
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 82
Maintenance 83
7.
Replace the screw.
8. If the configuration is parallel, reconnect the redundant signal cables.
9. Replace the front bezel.
10. Transfer the UPS to Normal mode (on page 65).
Replacing UPS X-Slot cards
This component is hot-swappable and can be replaced without powering down the UPS.
1. (optional) To replace the component with the UPS powered down, do one of the following:
o Standalone UPS configuration—See "Powering down the standalone UPS (on page 72)."
o Individual UPS in a parallel configurationSee "Powering down an individual paralleled UPS (on
page 72)."
o Parallel UPS configurationSee "Powering down the parallel system (on page 73)."
2. Disconnect the communications cable from the X-Slot Card.
Vista de pagina 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 114 115

Comentarios a estos manuales

Sin comentarios