Hp Integrity NonStop H-Series Manual de usuario descargar pdf (Pagina 27)

Installation and Configuration

WVP NonStop Storage Analyzer User Guide – 536988-001

- 27 -

Figure 2-18 Installation of Storage Analyzer

Each of the configuration parameters from 1 -6 can be changed by entering the number

against it and then entering the corresponding value. When ready to install, enter ‘7’ and the

installer will modify the necessary files and set the defaults for the Alerts and Runtime

configuration.

It then notifies the user whether the installation was successful or not. To start Storage

Analyzer, Web ViewPoint must be started manually.

Note1: Before starting Storage Analyzer, the binary SADLL must be licensed; otherwise the

fragmentation data for physical disks won’t be collected.

*Note 2:

The Hourly alerts are not currently being supported in Storage Analyzer. It’s reserved

for future release.

[Back to TOC]

2-2-7 Uninstallation of Storage Analyzer

NonStop Storage Analyzer (when installed manually) can be uninstalled by running RMVSA from

the SA installation sub volume.

It removes NonStop Storage Analyzer from Web ViewPoint by updating the WVPCONF,

WVPMENU, STRTWVP and STOPWVP files.

2-2-7-1 Overview

To uninstall NonStop Storage Analyzer, user will need to FTP just one file, RMVSA which is

located in the CD under \WS_SW\Manual\Binary and follow the procedure described below. This

is the only way to uninstall Storage Analyzer.

Note: If manual installation was used, RMVSA must be already present in the same $volume.sub

volume along with the installation files. If Wizard Install was used then the file needs to be

transferred manually as it is not transferred automatically by the wizard to the SA install Sub

volume.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 113 114

Sin comentarios

Hp Integrity NonStop H-Series Manual de usuario Pagina 27