Hp Netserver L Server series Manual de usuario descargar pdf (Pagina 114)

Chapter 12 Troubleshooting

108

WARNING There is a danger of explosion if the battery is incorrectly

installed. For your safety, never attempt to recharge,

disassemble, or burn the old battery. Replace only with the

same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer's

instructions.

1. Power down the HP Netserver and unplug power cord.

2. Gain access to the system board by following the appropriate instructions for

removing the chassis from the rack and removing the top cover.

Refer to Chapter 2, "Opening and Closing the HP Netserver," to gain

access to the system board.

3. If necessary, remove the PCI board to gain access to the battery.

See Figure 12-2.

4. Insert a small flat-blade screwdriver or similar tool between the battery and

spring latch. See Figure 12-3.

5. Push the spring latch away from battery to release the battery.

The spring contacts beneath the battery cause it to pop up allowing you to

grasp the battery.

6. Remove the existing battery.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 139 140

Sin comentarios

Hp Netserver L Server series Manual de usuario Pagina 114