Hp Netserver L Server series Manual de usuario descargar pdf (Pagina 18)

Chapter 2 Opening and Closing the HP Netserver

Figure 2-2. Removing the Top Cover

Replacing the Top Cover

To replace the top cover, follow these steps:

1. If the HP Netserver is already laying on a flat surface with no power applied,

continue with Step 5.

2. If the HP Netserver was operating with the cover removed, power down the

operating system and turn off the Netserver's power switch.

3. Disconnect the power cord and any cables attached to the Netserver.

4. Remove the Netserver chassis from the rack and lay it on a flat surface.

5. Ensure the knob is turned to the "Open" position (clockwise position).

See Figure 2-2.

Place the rear edge of the top cover on the rear edge of the chassis and lay it

down on the chassis.

6. Rotate the knob to the "Closed" position (counter clockwise position).

See Figure 2-3.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 139 140

Sin comentarios

Hp Netserver L Server series Manual de usuario Pagina 18