Hp NonStop G-Series Manual de usuario descargar pdf (Pagina 40)

Installing and Configuring the Nomadic Disk

Manager

ServerNet Nomadic Disk User’s Guide—425485-001

3-12

Nomadic Disk Manager Configuration Statements

PROCESS Statement

The Nomadic Disk Manager executes and communicates with several utilities. Use the

PROCESS statement to control where a specified utility executes and at what priority.

Each utility can have its own PROCESS statement, though none is required. Any utility

that does not have a PROCESS statement is started in the processor in which the

Nomadic Disk Manager TACL process is running, with a priority of one less than the

priority of the Manager TACL process.

proc-type

specifies the utility and is:

{FUP | SCF | SWCI }

cpu-spec

specifies the processor where the utility should run and is one of:

pri-spec

specifies the priority for the utility and is one of:

PROCESS proc-type CPU cpu-spec , PRI pri-spec

* Specifies the processor running the TACL process should be

used.

cpu Is an unsigned integer specifying the processor number.

{+|-}

int

Is a signed integer specifying a processor number relative to the

processor in which the TACL process is running.

Wraparound is supported; that is, if the TACL process is

executing in processor 2 of a four-processor system, a value of

CPU +2 results in processor number 0.

* Specifies the same priority as the TACL process.

pri Is an unsigned integer specifying the priority. Valid values are 1

through 199.

{+|-}

int

Is a signed integer specifying the priority relative to the priority

of the TACL process. Valid values for int are 1 through 100.

If the resulting priority is less than 1, the Manager sets it to 1. If

it is greater than 199, the Manager sets it to 199.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 145 146

Sin comentarios

Hp NonStop G-Series Manual de usuario Pagina 40