Hp ProLiant BL685c Server-Blade Manual de usuario descargar pdf (Pagina 18)

Setup 18

Interconnect device mapping

To support network connections for specific signals, install an interconnect module in the bay

corresponding to the embedded NIC or mezzanine signals.

Server blade signal Interconnect bay Interconnect bay labels

NIC 1 (Embedded) 1

NIC 2 (Embedded) 2

NIC 3 (Embedded) 1

NIC 4 (Embedded) 2

Mezzanine 1 3 and 4

Mezzanine 2 5 and 6

7 and 8

Mezzanine 3 7 and 8

5 and 6

For detailed port mapping information, see the HP BladeSystem enclosure installation poster or the

HP BladeSystem enclosure setup and installation guide on the HP website

(http://www.hp.com/go/bladesystem/documentation

Installing a server blade

The HP BladeSystem c7000 Enclosure ships with four device bay shelves to support half-height devices.

To install a full-height device, remove the device bay shelf and the corresponding blanks.

CAUTION: To prevent improper cooling and thermal damage, do not operate the server blade or the

enclosure unless all hard drive and device bays are populated with either a component or a blank.

To install a server blade:

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 92 93

Sin comentarios

Hp ProLiant BL685c Server-Blade Manual de usuario Pagina 18