Hp LC 2000 Manual de usuario descargar pdf (Pagina 150)

Chapter 12 Troubleshooting

142

8. Plug in the power cord, turn on power to the HP NetServer, and allow it to

complete its startup routine.

9. If you wish to set the password again, during the power-on system

hardware test press the F2 function key to start the Setup Utility.

10. Set the new password in the Security menu.

11. Press the F10 function key and answer "Yes" to save the configuration,

including the new password, and exit the Setup Utility.

Battery Problems

If your HP NetServer repeatedly loses its configuration or the CPU clock stops,

you should replace the battery.

WARNING There is a danger of explosion if the battery is incorrectly

installed. For your safety, never attempt to recharge,

disassemble, or burn the old battery. Replace only with the

same or equivalent type recommended by the manufacturer.

Dispose of used batteries safely.

To install a battery replacement, refer to the following procedure.

1. Turn off power to the HP NetServer, and unplug the power cord or power

cords.

Refer to Chapter 2, "Controls, Ports, and Indicators."

2. Remove the front bezel and left side cover (or top cover).

Refer to Chapter 3, "Opening and Closing the HP NetServer."

3. Remove the old battery, which is shown in Figure 12-2.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 193 194

Sin comentarios

Hp LC 2000 Manual de usuario Pagina 150