Hp LC 2000 Manual de usuario Pagina 61

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 60
Chapter 4 Installing Mass Storage Devices
53
Connecting External SCSI Devices
The HP NetServer may provide an external SCSI connector (optional) at the rear
panel knockout as shown in Figure 4-14. The external SCSI connector is typically
connected to a PCI SCSI disk controller board inserted in one of the PCI slots.
An external SCSI connection may also be provided by a SCSI disk controller
board or a DAC board inserted into one of the PCI slots as shown in Figure 4-14.
The last device in the SCSI chain of external devices must be terminated. See
Figure 4-14.
CAUTION Do not use high voltage differential (HVD) SCSI devices on
any of the SCSI channels or damage will occur. The HVD
SCSI devices are not supported. Use only Single-Ended (SE)
or Low-Voltage Differential (LVD) devices to connect to the
external connectors.
SCSI Drive
Controller Board
(Optional)
Figure 4-14. External SCSI Connection
Vista de pagina 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 193 194

Comentarios a estos manuales

Sin comentarios