Hp LC 2000 Manual de usuario Pagina 158
- Pagina / 194
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 13 Alternative Rack Mounting
150
Attaching the Slides to the Rack
This section provides the instructions for connecting the mounting slides to the
rack. The slides’ mounting flanges are not used in the HP System Rack and must
be detached before fastening the mounting slides in the rack. Instead of the
flanges, the studs on the slide are inserted in holes on the inside face (the side) of
the rack columns.
1. Use a nut driver or wrench to detach the two mounting flanges from each
slide. See Figure 13-3.
Brackets
S
l
i
d
e
Figure 13-3. Removing the Slides’ Mounting Flanges
2. Pull the anti-tip foot forward out of the bottom of the rack.
3. Hold the template alongside the inside face (side) of the left-front rack
column.
4. Line up the template with the bottom line of the rack space the NetServer
will occupy.
The template covers a span of 5 EIA units, which is the height requirement
of the NetServer.
5. Mark the single hole indicated by the template for future reference.
The template directs you to a single hole in the rack column used for
mounting the slide.
- HP NetServer LC 2000/2000r 1
- Installation Guide 1
- Contents 3
- 1 Setting Up the HP NetServer 9
- Pedestal Installation 10
- Rack Mount Installation 13
- Front of HP NetServer 17
- Front Panel LED Indicators 19
- Power Supply Module Indicator 23
- Keyboard Mouse 24
- Video NIC 24
- (Embedded) 24
- Management 24
- NIC Indicators 25
- Link/Activity 25
- Transfer Rate 25
- Powering Up the HP NetServer 26
- Sleep States (ACPI) 27
- 3 Opening and Closing the HP 29
- NetServer 29
- Foot (4) 31
- Anti-Tip 31
- Foot Extended 31
- Slide Securing Screws (2) 33
- Hinge Pins(3) Handles(2) 33
- Top Cover 35
- Bottom Cover 35
- Cover Pull 35
- Right Cover 38
- Thumbscrews (2) 38
- Removing the Pedestal 40
- Hardware Mirroring 43
- Mass Storage Guidelines 44
- • General Guidelines 44
- • SCSI Device Selection 44
- • SCSI Drive Addressing 45
- • Filler Panels and Spacers 46
- Filler Panels 47
- Pedestal Configurations for 48
- Note: Con = Connector 49
- Connectors A and B 50
- Con = Connector 50
- Cabling Configurations 51
- Drive Spacer 55
- Locking Latch 56
- Removing Hot Swap Hard Drives 58
- Non-Hot Swap 59
- (Optional) 59
- DIMM Installation 64
- DIMM Removal 67
- Boot Priority 70
- IRQ Settings 71
- System Board PCI Slots 71
- Installing Accessory Boards 73
- 1. Open Tab 75
- 2. Lift Latch 75
- 3. Remove Slot Cover 75
- 1. Insert Board 77
- 2. Close Latch 77
- 3. Turn Tab 77
- Figure 7-1. System Board 80
- Installing the Processor 81
- Processor Cage 83
- Terminator 84
- Figure 7-6. Installing VRM 86
- Channel(2) 97
- Rear of HP NetServer 101
- Left Rear 101
- Rack Column 101
- Cable Management Arm 101
- Attaching the Front Bezel 102
- Mouse, and UPS 105
- Introduction 107
- HP NetServer Navigator CD-ROM 107
- Internet FTP 109
- Assistant 111
- • Show System Information: 113
- • Configure Disk Array: 113
- • Install Utility Partition: 113
- • Execute Card Utilities: 113
- NOS Installation 115
- HP Management Solutions 116
- Setup Utility 120
- Using the Setup Screens 121
- • Small arrow points ( 122
- ➢Hardware Security 123
- Floppy check: [Disabled] 126
- Summary screen: [Enabled] 126
- Quick Boot mode: [Enabled] 126
- ➢Boot Device Priority 126
- ➢Hard Drive Priority 126
- Clearing CMOS 128
- SCSI Configuration Utility 129
- 11 Information Assistant 135
- Installing from the CD-ROM 137
- :\infoasst\setup 137
- 12 Troubleshooting 139
- Common Installation Problems 140
- Chapter 12 Troubleshooting 141
- Error Message Is Displayed 142
- No Error Messages Displayed 143
- Open = Off 145
- Closed = On 145
- Hardware Problems 147
- Keyboard or Mouse Do Not Work 148
- CD-ROM Drive Does Not Work 148
- Password Problems 149
- Battery Problems 150
- 13 Alternative Rack Mounting 153
- Tools Required 154
- • Nut driver or wrench 154
- • T-15 and T-25 Torx Drivers 154
- • Marking pen 154
- Preparing the Rack 156
- Mounting 161
- Channels(2) 162
- A Specifications 169
- Appendix A Specifications 170
- Environmental Requirements 171
- Physical Requirements 172
- Video Support 173
- B Regulatory Information 175
- Notice for Japan 177
- Notice for Korea 178
- Notice for Taiwan 179
- Notice for European Union 179
- Battery Statements 183
- C Service and Support 185
- Warranty 187
Relacionado con productos y manuales para Ordenadores Hp LC 2000
Ordenadores Hp ProLiant ML115HP Manual de usuario
(26 paginas)
(26 paginas)
Ordenadores Hp XW6400X Manual de usuario
(90 paginas)
(90 paginas)
Ordenadores Hp Slimline s3230 Manual de usuario
(2 paginas)
(2 paginas)
Ordenadores Hp 576X-B Manual de usuario
(1 paginas)
(1 paginas)
Ordenadores Hp Pavilion 414.uk Manual de usuario
(2 paginas)
(2 paginas)
Ordenadores Hp QUICKSPECS DL380 Manual de usuario
(56 paginas)
(56 paginas)
Ordenadores Hp BL2X220C Manual de usuario
(82 paginas)
(82 paginas)
Ordenadores Hp Vectra VL 5/xxx Manual de usuario
(102 paginas)
(102 paginas)
Ordenadores Hp BA322 90087 Manual de usuario
(346 paginas)
(346 paginas)
Ordenadores Hp XW6200 Manual de usuario
(78 paginas)
(78 paginas)
Ordenadores Hp ProLiant DL785 Manual de usuario
(42 paginas)
(42 paginas)
Ordenadores Hp LH 3r Manual de usuario
(23 paginas)
(23 paginas)
Ordenadores Hp S6150AP Manual de usuario
(1 paginas)
(1 paginas)
Ordenadores Hp T550 Manual de usuario
(2 paginas)
(2 paginas)
Ordenadores Hp Server Blades BL30p Manual de usuario
(38 paginas)
(38 paginas)
Ordenadores Hp Vectra 500 Series Manual de usuario
(146 paginas)
(146 paginas)
Ordenadores Hp XW4300 Manual de usuario
(85 paginas)
(85 paginas)
Ordenadores Hp AD117-9003A-ED3 Manual de usuario
(177 paginas)
(177 paginas)
Ordenadores Hp TC2120 Manual de usuario
(125 paginas)
(125 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.042 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales