
110 user’s guide
4 Push the release tab on the top of the hard drive bracket into the locked
position (L).
5 Replace the side panel. See page 99.
installing a second hard drive
Some PC models may have an empty bay to add a second hard drive. You must
provide the drive and four 6/32 x ¼” screws (length of ¼-inch is 0.64 cm) to
secure the drive to the chassis.
1 Remove the side panel. See page 99.
2 Remove the front panel. See page 100.
3 Gently lay the PC on its side.
4 See “removing the preinstalled hard drive” on page 107.
NOTE: You do not need to remove the preinstalled hard drive from the
bracket when installing a second hard drive.
5 Remove the two screws on the hard drive bracket (N).
O
N
P
6 Slide the bracket away from the bottom of the chassis, and then pull it up and
out of the chassis (O).
Comentarios a estos manuales