HP 12M Manual de instalación descargar pdf (Pagina 23)

2-9

Installing the HP 10/100 Hubs

Installation Procedures

Installing the HP 10/100 Hubs

Wall Mounting

You can mount the hub on a wall. Note that the hub should be mounted only

to a wall or wood surface that is at least 1/2-inch plywood or its equivalent.

1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting

brackets to the hub with the included 8-mm M4 screws as shown in the

illustration below.

2. Attach the hub to the wall or wood surface with two 5/8-inch number 12

wood screws (not included}.

4. Connect the Hub to a Power Source

1. Plug the included power cord into the hub’s power connector and into a

nearby AC power source.

2. Re-check the LEDs during self test. See “LED Behavior” on page 2-5.

For power precautions, see the section, “Installation Precautions” earlier in

this chapter. The HP 10/100 hubs do not have a power switch. They are

powered on when the power cord is connected to the hub and to a power

source.

8 mm M4 screws

5/8-inch

wood screws

9934.book Page 9 Thursday, January 14, 1999 12:39 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 65 66

Sin comentarios

HP 12M Manual de instalación Pagina 23