HP S10 Manual de usuario descargar pdf (Pagina 42)

40 Procedure 7: Verify the Connections

Procedure 7: Verify the Connections

After connecting devices and the server to the hub, verify the connections.

Note Because the hub is strictly a pass-through device for FC-AL traffic, there is no

hub address and the hub is not listed in ioscan output (HP-UX servers) or the

SCSI Adapters window (HP NetServers).

For HP-UX servers:

1. Use the following HP-UX command to run ioscan and check the hardware paths

between the server and the attached FC-AL devices:

ioscan -f

For details on ioscan and its options, refer to the HP-UX System Administration

Tasks Manual. Also consult the device documentation to interpret the ioscan output.

2. If the Hardware State of a device connected to the hub is “Unclaimed” or “No H/W,” see

chapter4, Troubleshooting, for more information.

For HP NetServers:

1. From the Start menu, select Settings, then select Control Panel.

2. Double-click the SCSI Adapters icon. The SCSI Adapters window appears.

3. Click the Devices tab, then verify that the FC-AL devices connected to the hub are

displayed.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 133 134

Sin comentarios

HP S10 Manual de usuario Pagina 42