HP S10 Manual de usuario descargar pdf (Pagina 74)

72 If the Power LED Is Off

If the Power LED Is Off

If the Power LED is off, find the symptom that best fits the situation, then attempt the

solution. When more than one solution is possible, the most likely one is listed first.

Symptom Cause/Solution

The hub is installed, but the

Power LED is off.

The power cord is not connected at both ends. Plug the

power cord in at the hub and the power source.

The power cord is plugged in, but

the Power LED is off.

– The line voltage is inadequate. Reactivate or adjust line

voltage.

– The power cord is bad. Replace the power cord.

– The hub is faulty. Replace the hub.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 133 134

Hewlett-Packard 1
SureStore E Hub 1
Models S10 and L10 1
Service and User Manual 3
Warranty 4
Trademark Information 4
Safety Instructions 4
Format Conventions 4
CONTENTS 5
Contents 7
1 PRODUCT DESCRIPTION 13
Overview 14
Features 15
Rear Panel 18
Supported Topologies 19
Maximum distance between 20
Supported Topologies 19 21
Product Description 21
2 INSTALLATION 23
Before installing the hub: 25
Procedure 2: Unpack the Hub 26
Installation 27
Installing Rails 30
Installing the Plenum Shroud 32
FC-AL Device 1 36
FC-AL Device 2 36
Incorrect Cabling Examples 37
Nonsupported Cabling Example 39
For HP-UX servers: 42
For HP NetServers: 42
3 RS-232 INTERFACE FUNCTIONS 43
About the RS-232 Main Menu 45
44 Overview 46
• FC-AL hub 47
• A null-modem serial cable 47
Updating the Hub Firmware 50
Procedure 2: Reboot the Hub 51
Procedure 5: Reset the Hub 55
Enabling Hub Management 59
• get community name 60
• set community name 61
• SNMP trap community name 61
• trap server IP addresses 61
• MIB-2 system name 61
• default values 61
Configuring Cascaded Hubs 62
Configuring the Parent Hub 63
Configuring the Child Hub 63
NTER> 64
Connecting the Hubs 65
Running Diagnostic Tests 66
Viewing Hub Information 67
4 TROUBLESHOOTING 69
Troubleshooting Procedures 70
Troubleshooting 71
LED Indicators 72
If the Power LED Is Off 74
If a Fan Is Not Operating 76
If a Port LED Is Off 78
New FLASH checksum = 0x12FC 84
5 MAINTENANCE AND REPLACEMENT 87
Introduction 88
Maintenance 89
Replacing the Fan Module 90
4. Remove the fan module 91
6 REFERENCE 93
Standard Configurations 94
NOTE: The long-wave hub 95
Configuration Options 97
Replacement Parts 99
Operating Requirements 102
Cable Plant Specifications 103
Supported Hardware 105
Supported Distances 106
Model L10 Long-Wave Hub 107
Environmental Specifications 109
Reference Documents 111
Regulatory Statements 112
Reference 113
E. VCCI Statement (Japan) 114
Laser Safety 115
B. Product Information 116
C. Usage Restrictions 116
Laser Safety 115 117
Declaration of Conformity 118
GLOSSARY 119
118 Glossary 120
Glossary 119 121
Glossary 121
120 Glossary 122
128 Index 130
Reader Comment Sheet 131
BUSINESS REPLY MAIL 132
*A3724-96009* 134

Comentarios a estos manuales

Sin comentarios

HP S10 Manual de usuario Pagina 74

Comentarios a estos manuales

Relacionado con productos y manuales para Redes HP S10