HP S10 Manual de usuario descargar pdf (Pagina 48)

46 Setting Up an RS-232 Connection

2. Run the terminal emulator application. Configure the terminal emulator to use the

following settings:

3. Press <ENTER> to display the hub configuration Main menu.

If the Main menu does not appear and the following message is displayed, press the

Reset button on the front panel of the hub:

pROBE+>

Setting Up a Connection to a Dumb Terminal

Setting up a connection between a dumb terminal and the hub requires the following

equipment:

• FC-AL hub

• Any terminal that supports VT100 emulation with no flow control

The terminal must be in vt100 mode before you continue with this procedure. Refer to

the terminal’s manual for more information.

• A null-modem serial cable

The cable must have a DB-9 female connector for connection to the hub.

To establish a connection, do the following:

1. Connect the serial cable between the RS-232 ports on the hub and the terminal.

2. Power on the terminal.

Baud rate: 19,200

Data bits: 8

Parity bits: none

Stop bits: 1

Parity check: off

Flow control: none

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 133 134

Sin comentarios

HP S10 Manual de usuario Pagina 48