HP Jetdirect 2700w USB Wireless Print Server Manual de usuario descargar pdf (Pagina 10)

c. Under the General section, select Wireless Wizard.

NOTE: You might need to type a password if security is enabled on the network.

d. When prompted, set the security level.

NOTE: HP printers with two or more network interfaces cannot bridge, route, or switch data.

●

WPA – Most common type of Wireless Network Security. A single password for all users

connecting to the Wireless Network.

●

WPA – Enterprise (802.1x) – More advanced Network Security. Each device connecting to the

Wireless Network requires a unique user name and password. Network Administrators need

to setup a username and password specic to that printer and install a CA-signed certicate

on the printer.

e. Follow the remaining on-screen prompts to complete the conguration.

f. Select Apply to save all congurations.

5. If the printer is in Config mode, reboot the printer to return the printer to a Ready state.

6. Make sure the HP Jetdirect 2700w IP address has been assigned.

NOTE: The wireless IP address is dierent than the printer’s IP address. It may take some time for the

HP Jetdirect 2700w IP address to display depending on the network speed.

●

For touchscreen control panels, select the wireless icon from the Home screen. A list of IP

addresses or host names associated with the printer are displayed.

●

For 4–line control panel displays, print a ‘How to Connect’ page from the main menu. If the

HP Jetdirect 2700w IP address is not listed, wait a few minutes and try again.

When the HP Jetdirect 2700w IP address is listed, you are ready to print. For information on how

to print, go to

www.hp.com/go/MobilePrinting.

Method two: Enable wireless printing on the control panel

NOTE: After connecting the HP Jetdirect, the printer defaults to Wireless Conguration mode. For initial

conguration, use the Embedded Web Server method to enable wireless printing. After completing the

conguration, reboot the printer to exit Wireless Conguration mode. Any additional conguration can be

performed from the control panel.

1. On the printer control panel, scroll to and open the following menus:

●

Administration

●

Network Settings

●

Wireless

●

Wireless Station

2. Select Wireless Radio, select On, and then select Save.

3. Select SSID, type the wireless network SSID provided by your system administrator previously, and

then select Save.

4 Chapter 1 Install an HP Jetdirect 2700w USB Wireless Print Server ENWW

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Comentarios a estos manuales

Sin comentarios

HP Jetdirect 2700w USB Wireless Print Server Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Redes HP Jetdirect 2700w USB Wireless Print Server