HP AlphaServer DS25 Instrucciones de operaciones descargar pdf (Pagina 224)

6.6.5 Configuring Dial-Out Alert

When you are not monitoring the system from a modem connection,

you can use the RMC dial-out alert feature to remain informed of sys-

tem status. If dial-out alert is enabled, and the RMC detects alarm con-

ditions within the managed system, it can call a preset pager number.

You must configure remote dial-in for the dial-out feature to be enabled. See

Section 6.6.4.

To set up the dial-out alert feature, enter the RMC from the COM1 serial ter-

minal or local VGA monitor.

Example 6–2 Dial-Out Alert Configuration

RMC> set dial

Dial String: ATXDT9,15085553333

RMC> set alert

Alert String: ,,,,,,5085553332#;

RMC> enable alert

RMC> clear alert

RMC> send alert

Alert detected!

RMC> clear alert

RMC> status

Alert Enable: Enabled

A typical alert situation might be as follows:

• The RMC detects an alarm condition, such as over temperature warning.

• The RMC dials your pager and sends a message identifying the system.

• You dial the system from a remote serial terminal.

• You enter the RMC, check system status with the env command, and, if the

situation requires, power down the managed system.

• When the problem is resolved, you power up and reboot the system.

6-22 DS25 Owner’s Guide

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 280 281

Sin comentarios

HP AlphaServer DS25 Instrucciones de operaciones Pagina 224