HP AlphaServer DS25 Instrucciones de operaciones descargar pdf (Pagina 45)

2.3.1 Selecting the Display Device

The SRM console environment variable determines to which display

device (VT-type terminal or VGA monitor) the console display is sent.

The console terminal that displays the SRM user interface can be either a serial

terminal (VT320 or higher, or equivalent) or a VGA monitor.

The SRM console environment variable determines the display device.

• If you use a VT-type device as the console terminal, set the console envi-

ronment variable to serial. The VT device should be connected to the se-

rial port COM1 or COM2.

• If you use a VGA monitor as the console terminal, set the console environ-

ment variable to graphics.

You can verify the display device with the SRM show console command and

change the display device with the SRM set console command. If you change

the display device setting, you must reset the system (with the Reset button or

the init command) to put the new setting into effect.

In the following example, the operator displays the current console device (a

graphics device) and then resets it to a serial device. After the system initial-

izes, output will be displayed on the serial terminal.

P00>>> show console

console graphics

P00>>> set console serial

P00>>> init

Operation 2-11

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 280 281

Sin comentarios

HP AlphaServer DS25 Instrucciones de operaciones Pagina 45