HP AlphaStation DS20 Guía de instalación descargar pdf (Pagina 32)

Linux Installation and Configuration Guide for AlphaServer 32

ECG513/0100

should use the F4 key to define the mount point of "/" for sda2 and “/usr” for sda4. Use the F6

key to select the "Normal" formatting of the drive for both partitions. Once those steps are

complete, press enter to continue.

When the window changes to the Installation Menu, select "Start Installation“ to start the process.

After all CD’s have been loaded select the “Main Menu” to finish the installation. After the

software has been loaded to the disk, the system will run the Linux OS, which will allow the user

to log into the OS. Upon logging in, as “root” follow the next steps to finalize the installation.

1. Type: swriteboot –f1 /dev/TdZ /boot/bootlx (where T is the type of drive, s

for SCSI or h for IDE; and Z is the letter of the drive you are booting; ex: dka0=sda,

dqa0=hda) For example: swriteboot –f1 /dev/sda /boot/bootlx for SCSI

2. Type: cd /boot

3. Type: mount /dev/hda /cdrom

4. Type: cp /cdrom/etc/vm_full.gz .

5. Type: umount /dev/hda

6. During installation the YAST utility doesn't recognize the swap partition as defined and

therefore no swap partition is found in the /etc/fstab file. You will need to edit the /etc/fstab

file to add the swap partition entry manually, as follows:

/dev/sda3 swap swap defaults 0 0

7. After you have completed modifying the /etc/fstab file, you will need to be initialize it with

the command mkswap /dev/sda3. The changes will take effect after the system is rebooted.

8. To configure the X window System type: sax

Following the prompts answering the questions appropriately for your system. Once this process

is completed, you should be able to run the command "startx" to make use of the graphical

interface.

9. Type: shutdown –h now

Post-Installation

System Resource Manager Configuration

Now will make the final configuration changes to be able to boot directly from the disk, instead

of the floppy or CD-ROM. You should now be at the SRM prompt, ">>>". Enter the following

commands to finalize the configuration.

You need to enter these commands:

>>>set boot_file 2/boot/vm_full.gz

>>>set bootdef_dev dka0

>>>set boot_osflags "root=/dev/sda2"

At the SRM prompt, you can now boot directly from the hard drive:

>>>boot

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 55 56

Sin comentarios

HP AlphaStation DS20 Guía de instalación Pagina 32