HP Apollo 9000 400t Manual de servicio Pagina 158

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 296
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 157
5-10 FRU Removal and Replacement
5.3.5 Winchester Disk Drive Removal and Replacement (Model 400t and 400dl)
Figure 5-8 shows how to remove a Winchester disk drive. Perform the following steps
to replace a drive:
1. Remove the screw that secures the drive to the system’s front panel.
2. Lift up the side of the drive thats nearest the front of the system unit and slip
the two tabs of the disk mounting bracket from their slots.
3. Disconnect the data and power cables from the drive.
4. Reverse these steps to replace the disk drive. Refer to Appendix A to verify that
the disk drive is jumpered correctly.
5. After replacing a Domain/OS drive, you must run options 7 and 1 of the invol
utility to add the badspot list and format the drive. For more information on the
invol command, see the Domain Hardware Utilities Reference
.
After replacing an HP-UX drive, you must use the mediainit command to
format the disk. For more information on the mediainit command, see the
HP UX Reference Volume 1: Section 1 manual.
Figure 5-8. Disk Drive Removal (Model 400t and 400dl)
Vista de pagina 157
1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 295 296

Comentarios a estos manuales

Sin comentarios