HP Compaq Elite 8300 Touch All-in-One Manual de usuario descargar pdf (Pagina 2)

TouchMD Computer Setup (version December 2012) Page 2

3. Make sure to adjust the wall mount arms with the included 3/16” hex key so arm move freely, but hold

in place. Also insure that the “Centris” head screw is adjusted with a #3 phillips head screwdriver to

hold the weight of the screen. FAILURE TO ADJUST THE

“CENTRIS” HEAD SCREW PROPERLY WILL RESULT IN A

RETURN VISIT CALL! When TouchMD installs, we usually turn

the screw until it won’t turn easily, then turn the screw

another ¼ turn. This is usually tight enough to hold the

screen in place but still adjust the computer screen with two

hands on the frame.

4. Unpack the computer. If mounting on the wall, remove the factory installed stand per the instructions

at the end of this document. Otherwise, setup at the desired desktop location and skip to step 9 below.

4.1. See Appendix A for HP Compaq Elite 8300 stand removal instructions

4.2. See Appendix B for HP TouchSmart 9300 Elite stand removal instructions

5. Prepare to mount the Touch

Screen Computer to the

Chief Wall Mount by

attaching top two screws

(use the medium length

screws included with the

mount bracket) to the VESA

mount 100mm hole pattern

on the Touch Screen

Computers. Leave screws half way out, do not tighten as this will allow you to set the computer on the

open slots of the mount centris head in step 6. See illustration A.

6. Lift the computer onto

open top slots of the

Chief wall mount centris

head and allow it to set

into place. Tighten top

screws on the Centris

Head to the VESA mount

to hold in place (See

illustration B). Attach

and tighten bottom two screws between the Centris Head and the VESA mount to secure to computer

to the Chief wall mount (See Illustration C).

1 2 3 4 5 6 7 8 9 10

Sin comentarios

HP Compaq Elite 8300 Touch All-in-One Manual de usuario Pagina 2