HP Compaq Elite 8300 Touch All-in-One Manual de usuario descargar pdf (Pagina 3)

TouchMD Computer Setup (version December 2012) Page 3

7. Run cables to computer and conceal inside wall mount arms per the Chief FWD or FWDSK cable

management instructions. Use the small screws and metal cord covers included with the wall mount

(see illustration D). Attach the screws to the bottom of the mounts, tighten half way, and push the

cables up into the arm (see illustration E). With the cables in place, twist the metal plate onto the

screws and tighten the screws (see illustration F). Repeat the above steps until the cables are conceal

in both arms (see illustration G)

8. For HP TouchSmart 9300 computers, use double

stick tape to attach the power supply to the wall

next to the wall mount (See illustration H). This step

is not needed for HP Compaq Elite 8300 computers

as the power supply is inside the computer.

9. Plug in and turn on computer.

10. If the computer was dropped shipped directly from

HP, you will need to perform the “Windows 7 Setup”

and “Installing LogMeIn” instructions below.

Otherwise, skip to step 11.

11. Connect the computer to the wireless network in the Office. The wireless network password will be

provided by the site contact.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

HP Compaq Elite 8300 Touch All-in-One Manual de usuario Pagina 3