HP NetServer LP 2000r Guía de usuario descargar pdf (Pagina 49)

Chapter 5 Installing Additional Boards

10. Replace the top cover on the HP Netserver and push the Netserver back

into the rack.

Once the HP Netserver is returned to normal operation, you may need to

install software drivers.

The drivers for the new PCI board are either part of your existing system

software or included on a flexible diskette or CD-ROM provided with the

accessory board.

Removing an Accessory Board

Follow the steps in the preceding section “Installing an Accessory Board,” but

instead of installing a card, remove the PCI card and replace the slot cover.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 135 136

HP Netserver LP 2000r 1
User Guide 1
Audience Assumptions 2
Contents 3
Front Panel 7
Power On/Off/Sleep 8
Switch & LED 8
Reset Switch 8
Rear Panel 10
Power Supply LED 11
Link LED 11
LAN Speed LED 11
Powering-Up the HP Netserver 12
Sleep States (ACPI) 13
2 Opening and Closing the HP 15
Netserver 15
Replacing the Front Bezel 16
Removing the Top Cover 16
Replacing the Top Cover 17
Removing the Air Flow Guide 18
Replacing the Air Flow Guide 18
Removing the PCI Card Cage 19
Replacing the PCI Card Cage 20
• SCSI Device Selection 22
• SCSI Drive Addressing 22
• Filler Panels 22
Boot Priority 23
Hardware Mirroring 24
Removing Hot Swap Hard Drives 27
Top Connector 31
Bottom Connector 31
Backplane B 32
Fold Cables 33
Installing Additional DIMMs 36
Retaining Latches (2) 39
DIMM Slot 39
Removing DIMMs 40
IRQ Settings 42
Remote Control Card 43
Installing an Accessory Board 44
Removing an Accessory Board 49
Installing a Second Processor 52
ZIF Lever 54
Terminator 54
Processor 54
Installing the Heatsink 56
Firmware and Software Changes 58
(4-Post) 61
Marking Rack Columns 64
Installing Slides in the Rack 65
View Rotated 90 Degrees CCW 66
Spring Tab 66
(2-Post) 73
Preparing the HP Netserver 77
Mouse, and Power Supplies 83
Release Lever 85
HP Netserver Navigator CD-ROM 89
• HP models supported 90
• Internet WWW 91
HP Management Solutions 92
DiagTools 93
Setup (BIOS) Utility 93
Menu Bar 94
Using the Setup Screens 95
➢Power-On Password 97
Hardware Security 97
SCSI Configuration Utility 98
Overview 101
12 Troubleshooting 103
Common Installation Problems 104
Netserver Will Not Power On 105
Chapter 12 Troubleshooting 106
Resetting a Lost Password 108
Hardware Problems 109
CD-ROM Drive Does Not Work 110
SCSI Device Does Not Work 110
Replacing a Battery 111
Introduction 113
Tools Required 114
Rack Configuration Tools 114
Safety Precautions 115
Marking the Columns 116
Attaching the Front Bezel 122
Cabling Rack Components 122
A Specifications 125
° to 35° C (41° to 95° F) 126
Appendix A Specifications 127
System Board Layout 128

Comentarios a estos manuales

Sin comentarios

HP NetServer LP 2000r Guía de usuario Pagina 49

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo HP NetServer LP 2000r