HP rp2450 Manual Pagina 82

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 202
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 81
Chapter
Server Slide Rail Installation
90
The following illustration shows rail parts only. Plastic parts bags, plastic end caps, and the cable
management device is not shown:
NOTE This illustration shows non-E-series HP cabinet columns
The following procedures list the steps required to install a stand-alone server in a cabinet.
Step 1. Attach rear slide mounts to the outer rails using M4 x 0.7mm screws. Do not fully tighten screws.
Allow the rear slide mount to move along slot in the outer rail.
Vista de pagina 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 201 202

Comentarios a estos manuales

Sin comentarios