HP Vectra XE320 Guía para resolver problemas descargar pdf (Pagina 13)

Upgrading and Replacing PC Hardware

Installing a Memory Module

WARNING

For your safety, disconnect the power cord and all external cables.

Note Only use HP memory modules provided for your PC model. The use of other memory modules is not supported. For information about

supported HP accessories, connect to

www.hp.com/go/pcaccessories

1 Switch off the PC, disconnect the power cord and remove the PC’s side panel (refer to “Removing

and Replacing the Side Panel” on page 12).

2 Lay the PC on its side so you can access the system board.

3 Either remove the module you want to replace or locate an empty memory module socket.

4 Make sure that the socket’s clips are open.

5 Align the grooves on the bottom of the module with the corresponding marks on the socket and push

it firmly into place. The clips close automatically.

Caution

You may damage the system board if you attempt to install a memory module the wrong way round.

6 Replace the PC’s side panel (refer to “Removing and Replacing the Side Panel” on page 12).

7 Reconnect the power cord.

Position of memory modules

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sin comentarios

HP Vectra XE320 Guía para resolver problemas Pagina 13