HP Vectra XE320 Guía para resolver problemas descargar pdf (Pagina 23)

Upgrading and Replacing PC Hardware

4 Slide the old drive out of the front of the PC.

5 Check that the jumpers on the rear of the new drive are set to CS (cable select) mode.

6 Slide the new drive in from the front of the PC.

7 Replace the two screws.

8 Replace the data and power cables. If your PC is a Linux model, replace the audio cable.

9 Replace the PC’s side panel (refer to “Removing and Replacing the Side Panel” on page 12).

10 Reconnect the power cord.

Installing a Drive in the Lower Expansion Bay

WARNING

For your safety, disconnect the power cord and all external cables.

1 Switch off the PC, disconnect the power cord and remove the PC’s side panel (refer to “Removing and

Replacing the Side Panel” on page 12).

2 Remove the plastic masking plate from the front panel by pushing the retaining tab inwards with a

screwdriver.

audio cable (only

required for Linux

models)

masking plate

retaining tab

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

HP Vectra XE320 Guía para resolver problemas Pagina 23