HP Vectra XE320 Guía para resolver problemas descargar pdf (Pagina 14)

Upgrading and Replacing PC Hardware

Installing an AGP or PCI Expansion Card

WARNING

For your safety, disconnect the power cord and all external cables.

1 Switch off the PC, disconnect the power cord and remove the PC’s side panel (refer to “Removing and

Replacing the Side Panel” on page 12).

2 Locate the slot you want to use.

•

If you are fitting a card in an empty slot, undo the screw holding the slot cover in place and remove

it.

•

If you are replacing a card in an expansion slot, undo the screw holding the card in place and lift it

out. If in addition, this card is an AGP card, open the plastic latch at the end of the slot.

3 Aligning the new card carefully, press it firmly into the socket and tighten the retaining screw.

4 If your are installing or replacing an AGP card, close the latch located at the side of the slot.

5 Replace the PC’s side panel (refer to “Removing and Replacing the Side Panel” on page 12).

6 Reconnect the power cord.

plastic latch on AGP slot

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Sin comentarios

HP Vectra XE320 Guía para resolver problemas Pagina 14