HP Server tc2110 Guía de usuario descargar pdf (Pagina 78)

Chapter 6 Maintenance and Troubleshooting

LEDs are not lit on the NIC

No lit LEDs probably indicates a bad network cable, hub connection, or other network error.

1. Ensure that the cabling is installed correctly:

a. Try another known good network cable.

b. Try another network connection (another hub, switch, etc.)

c. Connect the NIC to a known good network connection.

If there are still no lit LEDs, do the following:

2. Power off the HP Server and unplug the power cord/s from the power source. Remove the left side

cover.

NOTE The HP Server tc2110 has an integrated NIC so skip the following steps unless a PCI NIC

is installed in the server.

CAUTION Always wear an antistatic wrist guard when working inside the HP Server.

3. Locate the NIC and reseat it in its slot.

4. Replace the covers; plug in the power cord/s to a power source, and power on the HP Server.

5. If the problem persists, perform previous step 2 and 3 but move the NIC to another slot.

6. Replace the covers; plug in the power cord/s to a power source, and power on the HP Server.

If the problem persists, contact the HP Customer Support Center for further troubleshooting assistance before

replacing any parts.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 117 118

Sin comentarios

HP Server tc2110 Guía de usuario Pagina 78