HP 441877-00F Manual de usuario descargar pdf (Pagina 16)

Installation 16

# BIND IPX Q57_1_E82 NET=FAFD3D25

# LOAD Q57 SLOT=2 FRAME=Ethernet_802.3 NAME=Q57_1_E83

# BIND IPX Q57_1_E83 NET=5A2D8D6D

# LOAD Q57 SLOT=2 FRAME=Ethernet_SNAP NAME=Q57_1_ESP

# BIND IPX Q57_1_ESP NET=477A35BD

# LOAD Q57 SLOT=2 FRAME=Ethernet_II NAME=Q57_1_EII

# BIND IPX Q57_1_EII NET=C3C8F2E4

# BIND IP Q57_1_EII ADDR=172.16.1.1 MASK=ff.ff.0.0

NetWare server driver LOAD line parameters

This following lists the NetWare server driver LOAD line parameter settings for HP server adapters for

N100, N1000, and N1000e.

• FORCEDUPLEX. This keyword specifies one of the following duplex modes:

o Auto-negotiate. The adapter negotiates with the switch and hub how to send and receive packets

at either full- or half-duplex speed. If unsuccessful at negotiating the duplex, HP server adapters

default to half-duplex. You must have an auto-negotiating switch/hub (an Nway switch) to get

full-duplex support with the FORCEDUPLEX parameter set to 0 (auto-negotiation).

o Full-duplex. The adapter sends and receives packets at the same time. This improves the

performance of your adapter. Set duplex mode to full-duplex ONLY if you have a hub/switch

that supports full-duplex.

o Half-duplex. The adapter performs one operation at a time. It either transmits or receives. To set

the adapter to half- or full-duplex mode, you must set the SPEED parameter to either 10 or 100.

NOTE: The HP NC31xx, 340T, and NC71xx Server Adapters support full-duplex and half-

duplex. The HP NC61xx fiber Gigabit Server Adapters support full-duplex mode only and

cannot be changed.

o Syntax: FORCEDUPLEX=n

Where n =

0—auto-negotiate

1—half-duplex

2—full-duplex

o Default = auto-negotiate

o Examples:

100 Mbps full-duplex FORCEDUPLEX=2 SPEED=100

10 Mbps full-duplex FORCEDUPLEX=2 SPEED=10

• SLOT. (Required) For PCI adapters, SLOT is derived from bus number and device location as defined

by the PCI specification. One way to determine the slot number is to load the driver from the

command line. You will be prompted with valid device number(s) for the adapter(s). Select one of

them.

o Syntax: SLOT=n

Where n = 1, 2, 3, 4,...

• SPEED. This keyword specifies the speed the driver uses. If you do not use this parameter, the driver

automatically detects the network speed. If unable to detect, the driver defaults to 10 Mbps. If you

use this parameter, the driver operates at the specified speed instead of auto detecting network

speed.

o Syntax: SPEED=n

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 66 67

Comentarios a estos manuales

Sin comentarios

HP 441877-00F Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP 441877-00F