Installation 19
• PRIMARY
o Syntax: primary | secondary
o Description: Identifies the primary adapter. Supported only in BIND command
• PROBE_BURST_SIZE
o Syntax: probe_burst_size=nnn
o Description: Changes number of probes to send in a retry
• PROBE_CHECK_INTERVAL
o Syntax: probe_check_interval=nnn
o Description: Changes probes check interval
• PROBE_RECHECK_INTERVAL
o Syntax: probe_recheck_interval=nnn
o Description: Changes probe retries check interval
• PROBE_RETRY_COUNT
o Syntax: probe_retry_count=nnn
o Description: Changes probes retry count
• PROBE_SEND_INTERVAL
o Syntax: probe_send_interval=nnn
o Description: Changes probes send interval, nnn counts 1/18 sec
• PROBE_SET_DEFAULT
o Syntax: probe_set_default
o Description: Restores probes settings to factory settings
• PROBES
o Syntax: probes=[on | off]
o Description: Enables/disables probes
• PROBES
o Syntax: probes=[BROADCAST|MULTICAST]
o Description: Changes probes addressing
• RECOMMIT
o Syntax: recommit [team=nnn]
o Description: Resets a certain mode. Use after hot binding to base drivers with Team=nnn
• REMOVETEAM
o Syntax: removeteam [team=nnn]
o Description: Removes a team. Use after hot binding to base drivers with Team=nnn
• REMOVEVLANID
o Syntax: RemoveVlanID=nnn
o Description: Removes the selected VLAN
• RESET
o Syntax: RESET LBN=nnn
Comentarios a estos manuales