HP 441877-00F Manual de usuario Pagina 31

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 67
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 30
Adapter configurations 31
o 1 Gb Full Auto. Sets the speed to 1 Gbps and mode to Full-Duplex
o 10 Mb Full. Sets the speed to 10 Mbps and mode to Full-Duplex
o 10 Mb Half. Sets the speed to 10 Mbps and mode to Half-Duplex
o 100 Mb Full. Sets the speed to 100 Mbps and mode to Full-Duplex
o 100 Mb Half. Sets the speed to 100 Mbps and mode to Half-Duplex
o Auto. (Default) Sets the speed and mode for optimum network connection (recommended)
TCP/UDP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation
of TCP or UDP checksum over IPv4 packets. If this TCP/UDP Checksum Offload (IPv4) property is
present, it overrides the TCP Checksum Offload (IPv4) and UDP Checksum Offload (IPv4) properties
and they are disabled.
o Default = Rx/Tx Enabled
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enabled
TCP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of
TCP Checksum over IPv4 packets.
o Default = Rx/Tx Enable
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
UDP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of
UDP checksum over IPv4 packets.
o Default = Rx/Tx Enable
o Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
VLAN ID. The user assigned identifier for a VLAN.
o Range: 1–4094
Wake Up Capabilities. Determines the type of packets that will cause the adapter to wake up the
system.
o Default = Both
o Range = Both; Magic Packet; None; Wake Up Frame
WOL Speed. (Not supported on NC150T, NC37x, NC380T, NC67xx, and NC7782 adapters)
Specifies the speed at which the adapter connects to the network during Wake-on-LAN mode.
o Default = Auto
o Range = Auto; 10 Mb; 100 Mb
Multifunction Gigabit Server adapter properties
iSCSI VLAN. Allows you to create a VLAN for an iSCSI-enabled device.
Receive-Side Scaling (RSS). Enables dynamic load balancing of incoming traffic across CPUs.
Microsoft Scalable Networking Pack (SNP) is required when enabling TOE and RSS.
o Default = Enable
o Range = Enable; Disable
Vista de pagina 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 66 67

Comentarios a estos manuales

Sin comentarios