HP PROCURVE 6600 Manual de usuario descargar pdf (Pagina 158)

100

101

Switch Memory and Configuration

Multiple Configuration Files

Pressing Clear + Reset:

– Replaces all startup-config files with a single

file named config1 that contains the default

configuration for the software version in

primary flash.

– Resets the Active, Primary, and Secondary

assignments as shown here.

Figure 6-25. Example of Clear + Reset Result

Transferring Startup-Config Files To or From a Remote

Server

Command Page

copy config < src-file > tftp < ip-addr > < remote-file > < pc | unix > [oobm] below

copy tftp config < dest-file > < ip-addr > < remote-file > < pc | unix > [oobm] below

copy config < src-file > xmodem < pc | unix > 6-40

copy xmodem config < dest-file > < pc | unix > 6-40

TFTP: Copying a Configuration File to a Remote Host

Syntax: copy config < src-file > tftp < ip-addr > < remote-file > < pc | unix > [oobm]

This is an addition to the copy tftp command options. Use

this command to upload a configuration file from the switch

to a TFTP server.

For switches that have a separate out-of-band management

port, the oobm parameter specifies that the TFTP traffic will

go out through the out-of-band management interface. If this

parameter is not specified, the TFTP traffic goes out through

the data interface. The oobm parameter is not available on

switches that do not have a separate out-of-band management

port. Refer to Appendix I, “Network Out-of-Band

Management” in this guide for more information on out-of-

band management.

For more on using TFTP to copy a file to a remote server, refer

to “TFTP: Copying a Configuration File to a Remote Host” on

page A-30.

6-38

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 853 854

Comentarios a estos manuales

Sin comentarios

HP PROCURVE 6600 Manual de usuario Pagina 158

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP PROCURVE 6600