HP PROCURVE 6600 Manual de usuario descargar pdf (Pagina 493)

100

101

---- ---------------------------------------- -------- ----------- ---------

Redundancy (Switches 8200zl)

Using Redundant Management

ProCurve(config)# redundancy management-module

All configuration files and software images on the off-line management

module will be overwritten with the data from the current active

management module. Do you want to continue [y/n]? y

ProCurve(config)#

ProCurve(config)# show redundancy

Settings

------- -

Mgmt Redundancy : enabled

Redundancy enabled

Statistics

--------- -

Failovers : 0

Last Failover :

Slot Module Description Status SW Version Boot Image

1 ProCurve J9092A Management Module 8200zl Standby K.12.XX Primary

2 ProCurve J9092A Management Module 8200zl Active K.12.XX Primary

1 ProCurve J9093A F2 Fabric Module 8200zl Enabled

2 ProCurve J9093A F2 Fabric Module 8200zl Enabled

Figure 15-2. Example of Enabling Redundancy

The no version of the redundancy management-module command is used to

disable redundancy on the switch, as seen in Figure 15-3. The show redundancy

command displays “Mgmt Redundancy” as disabled. The standby

management module in slot 1 is now offline. The management module in slot

2 remains the active management module.

Note ProCurve recommends that you leave redundancy enabled. If the active

management module has a hardware failure, the standby module may take

over and may have an old configuration since file synchronization has not

occurred.

The redundancy management-module command allows you to shut down a

management module that is not functioning correctly without physically

removing the module. However, removing the management module is the

recommended method.

15-7

1 2 ... 488 489 490 491 492 493 494 495 496 497 498 ... 853 854

Comentarios a estos manuales

Sin comentarios

HP PROCURVE 6600 Manual de usuario Pagina 493

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP PROCURVE 6600