Hp Tape Library Interface Manager Software Manual de usuario Pagina 78

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 138
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 77
78 SAN Environments Chapter 4
Installation and Configuration
This section explains how to install and configure the HP Surestore Interface
Manager within HP SAN backup solutions. Basic knowledge about installing
and configuring tape libraries, Host Bus Adapters (HBAs), and software in a
non-SAN configuration is required.
This section’s instructions are based on the following example configuration:
HP-UX server with two HBAs
Windows NT server with one HBA
8-port HP Brocade Fibre Channel switch
HP 20/700 tape library with 2 DLT8000 drives
Fibre Channel Interface Manager
Note Each actual installation should be verified against the guidelines
of HP supported SAN Backup Solutions. See Table 5 on page 20
for a list of supported products. Contact your HP representative
for the most recent information.
Vista de pagina 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 137 138

Comentarios a estos manuales

Sin comentarios