
82 SAN Environments Chapter 4
2. From the Device & Media Management screen select:
Configure the library and drives so all nodes on the SAN can share them:
— Configure a single tape library
— Control the robotic arm from a single server, such as the cell server
—Do not check the SCSI Reserve/Release box (see Figure 21)
Figure 21 Logical Device Editor - SCSI-II Library
3. Configure each tape drive for each host that will access it.
In this example with two tape drives and two hosts, four tape drives must
be configured.
4. Select a Library device in the Device & Media Management screen shown
in Figure 20 on page 81, then right click and select:
The Logical Device Editor - Drive screen shown in Figure 22 appears.
Edit -> Create -> SCSI-II Library
Create -> Drive
Comentarios a estos manuales