HP EliteDesk 800 G4 Base Model Small Form Factor PC Manual de usuario descargar pdf (Pagina 42)

6. Connect the power cable and data cable to the rear of the drive.

7. Connect the opposite end of the data cable to one of the light-blue SATA connectors on the system board

labeled SATA1 or SATA2.

NOTE: Refer to System board connections on page 22 for an illustration of the system board drive

connectors.

8. Reassemble the computer.

Removing a 3.5-inch hard drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you

can transfer the data to the new hard drive.

There are two 3.5-inch hard drive bays. The procedure for removing a 3.5-inch hard drive is the same for each

drive bay.

1. Prepare the computer for disassembly (Preparation for disassembly on page 17).

2. Remove the access panel (Access panel on page 18).

3. Disconnect the power cable (1) and data cable (2) from the rear of the hard drive.

34 Chapter 4 Removal and replacement procedures

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 143 144

Sin comentarios

HP EliteDesk 800 G4 Base Model Small Form Factor PC Manual de usuario Pagina 42