HP LX195 MediaSmart Server Manual de usuario Pagina 149

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 236
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 148
Troubleshooting & FAQs
143
8. Click Next on the Rebooting your server into recovery mode dialog box and
follow the instructions on each dialog box.
During Server Recovery, the following may happen:
If the recovery program cannot find the server, see No Server Found.
If the Server Recovery cannot recover the partition data, the progress bar
will go to 100% and then back to zero and start over.
If the recovery fails, see Server Recovery Fails.
9. The server restarts after the Server Recovery or Factory Reset completes. Wait
until the Health indicator is solid aqua white
before proceeding to the next
step.
10. Click Finish on the Server recovery complete dialog box.
The HP MediaSmart Server software is automatically installed on the computer
where you performed the Server Recovery or Factory Reset.
11. Run the Software Installation Disc on each additional network computer. For
additional information, see Installing the Software on Additional Home
Computers.
Caution
If you did not close the HP MediaSmart Server Control Center, as indicated in
step 1, you may see a message asking you to reboot your computer. If you see this
message, choose to reboot later. Otherwise, rebooting may leave the server in a
state where it cannot be configured, and you will have to repeat the recovery or
reset process.
Vista de pagina 148
1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 235 236

Comentarios a estos manuales

Sin comentarios