HP LX195 MediaSmart Server Manual de usuario Pagina 150

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 236
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 149
HP MediaSmart Server User's Guide
144
Note
It takes a few minutes for the server to go through the finishing process. Please be
patient.
Troubleshooting Server Recovery
No Server Found
If the recovery program cannot find the server, the most likely causes are:
The Recovery Mode was not successfully initiated—repeat step 7 if you did not
push the recessed mode button while the Health indicator light was blinking aqua
white and red .
A firewall is blocking the connection - configure the firewall to allow the
Windows Home Server Recovery application or to allow connections over TCP
port 8192 and UDP port 8192. If opening these ports, be sure to close them after
the recovery has completed. For more information, see the vendor’s
documentation.
The network connection is not working. For troubleshooting network connections,
see Server Recovery Fails below.
Server Recovery Fails
If the server recovery fails, one of the following messages displays:
The server disks could not be reformatted
The partition data on the server could not be written
The primary volume on the server could not be written
The recovery image could not be loaded
The most likely causes of these messages is a network connection failure.
1. Make sure the Ethernet cable is connected directly to the server and the computer
you are using to do the recovery. The Ethernet cable should not be connected to a
router or switch.
2. Make sure the Ethernet cable is plugged in and securely connected to the server
and the computer you are using to do the recovery.
3. Repeat the recovery or reset.
Backing Up and Restoring a Computer
Backing up and restoring a computer is available through the Backups & Computers tab
on the Windows Home Server console.
To access the Backups & Computers tab
1. At the computer, double-click the Windows Home Server icon in the system
tray.
2. Log on to the Windows Home Server Console.
3. Click the Backups & Computers tab.
Vista de pagina 149
1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 235 236

Comentarios a estos manuales

Sin comentarios